Model 258

2 1/2" to 8" Diameter Pipe
The RIDGID Model 258 Power Pipe Cutter cuts 21/2" to 8" schedule 10*/40 steel pipe, galvanized pipe, rigid conduit etc. at the job site or in the shop. Powered by the RIDGID No. 700 Power Drive, the 258 is a displacement cutter that provides square cuts. The operator controls the feeding rate by pumping the hydraulic foot pump throughout the operation. A square cut with minimal burr on either 21' or nipple lengths of pipe is achieved quickly** without abrasive dust, sparks, or open flame. Also, the RIDGID Pipe Roller for Beveling can be used to rotate the pipe while a second operator uses a grinder to bevel the pipe.

	Square cut 21' or nipple lengths of pipe without effort.
	Easily cuts by displacing instead of removing pipe material.
	No abrasive dust, dangerous sparks, or open flame.
	Quickly cuts steel pipe with minimal burr.
	Great for cutting pipe for groove joining.
	Heavy-duty design is perfect for field or shop use.
	Adaptable for beveling.

	Cutting Capacity: Model 258 21/2" to 8" schedule.
	10*/40 steel pipe.
	Model 700 Power Drive.
	Power Drive RPM: 33 (no load).
	Weight: 105 lbs. (excludes No. 700 Power Drive)

	One (1) RIDGID 774 Square Drive Adapter.
	One (1) 8 1/2" HD Cutter Wheel Assembly.
	One (1) Hydraulic Ram and Foot Pump.
	Two (2) 2 1/2" to 12" Ball Transfer Pipe Supports.
* Use the thin cutter wheel for best results. ** Cutting time varies with pipe schedule and diameter. Note: Models 258 and 258XL are not recommended to cut cast iron pipe. For optimum wheel life always properly support the work piece with pipe supports.